The purpose of bit LBA is to provide support for hard disks larger than gigabytes gigabytes decimal. I get a lot of people asking for these modded BIOS'. They're still up, but I've renamed them to match Abit's original files. I did this so all that's necessary for you to do is pick up Abit's original BIOS update package and replace the. BIN file with my modded version. Prepare a DOS diskette with no Config.
If you have trouble fitting everything on the diskette, go to Folder Options, click on the View tab and enable display of Hidden and System Files and uncheck the box to Hide Protected and Operating System Files and respond "yes" to the warning. Then go back and delete everything on the diskette except IO.
These three are the only files required to boot to a clean DOS prompt everything else is either utilities or device drivers that you do not need. Once your DOS diskette is prepared, copy Abitfae. BIN to it. Using isa slot for iomega tape backup. Problem is I have an A drive icon but it is not for the ls The ls is the f drive.
I belive the computor is assigneing the A drive to the tape backup. I want to make the ls the A drive and the tape drive the f drive. If I click on the A drive in my computor to ask for property's the computor lock up and does not respond. Al the hardware works. But several programs demand that the a drive be the floppy. For example In add and remove programs If I try to make a rescue diskett and I put the diskett in the F drive to use the ls and cllick ok to make rescue disk MY windows 98 second edition says I can only crate rescue disk in the a drive for floppy disk.
Before I purchase this mother board with a amd thunderbird I had a pentium 2 On this system the ls was the a drive floppy and it wa still connected to the ide slot. How can I solve this problem? I am not a computor whiz but so far a cople of local repair shops are not either and have no suggestions. Appreciate any help. Joined Dec 2, Messages 12, How do I get my LS drive to work? The following procedure has been reported as successful: 1.
Other solutions Another user found the above solution did not work, but that by simply setting the IDE channel on which the LS is installed to "None" i. While we never noticed any instability that was caused by the lack of a fan on the chip, ABIT did much more than simply stick a fan on the heatsink to make the board look "cool. For starters, you have to remember that on Slot-A motherboards there is normally airflow. This airflow. Because of the price point of the KT7-RAID, and the fact that many users would like to run the more cost effective Duron processors on the board, we would've rather had ABIT leave out the fan if it did in fact drop the retail price of the motherboard since there isn't really a need for it although it doesn't hurt to have.
Form Factor. Bus Speeds. Voltages Supported. Award Flash Award Flase. AFlash Asus. CBROM v1. The program is called " Awardmod " and is written under the GPL. Awardmod can be downloaded from here. Version 2. CBROM 1. There are ready to use logos or you can make your own new logo. CBROM v2. CBROM v6. AMI Flash. AMI2 Setup. Phoenix Flash Loader. Latest flash loader for eSupport. Flash loader version 1. S3 Chipset Detect. Link to utility to identify your S3 Graphics chipset.
Check CPU. Clear CMOS. ACPI Test. Boot Disk. Copy QM. Fast Maxtor's 32 bit disk driver for windows 3.
0コメント